Configuring the Board

This section presents the necessary board settings in order to run Linux on the Arrow SoCKit Evaluation Board.
  • Configure the BOOTSELECT and CLOCKSELECT jumpers as shown in the figure below.
  • BOOTSELECT[2:0] = 101, CLOCKSELECT[1:0] = 00

config jumpers 14 0.jpg

SW6 is found on the bottom side of the SoCKit Evaluation Board. It is used to set the FPGA configuration mode.
  • Set MSEL[0:4] = 01010 (Fast Passive Parallel (FPP) x32 compressed mode).
msel 14.0.jpg

Give us your feedback

© 1999-2017 RocketBoards.org by the contributing authors. All material on this collaboration platform is the property of the contributing authors. Privacy.